BMW K1200, K1300, and K1600 Forum banner

Big Mak Shelf and Wiring

1K views 4 replies 3 participants last post by  messenger13 
#1 · (Edited)
I am going to try to install the Zumo this weekend. I am not the most mechanically inclined and need some feedback. Where is the best place to run the wires for the puck and my escort ? .

Also, The shelf has a conflict with my Ztechnick mount. So i need to move the Escort.

Retroboy
 
#2 ·
retroboy said:
I am going to try to install the Zumo this weekend. I am not the most mechanically inclined and need some feedback. Where is the best place to run the wires for the puck and my escort ? .

Also, The shelf has a conflict with my Ztechnick mount. So i need to move the Escort.

Retroboy
Remove the windshield and the top of the cowling (if it's still there, the Big Mak replaces it).
Remove the bezel around the instruments, it's two screws on top and two tabs on the bottom (see my post on the HID install to get an idea of what the tab's look like). The Big Mak shelf has big holes drilled in it, run your wires thru there and then behind the instruments. Fish them out and route. Replace bezel and install Big Mak
 
#5 ·
FWIW...I'll be installing a few things tomorrow and posting pics late tomorrow night. On deck I have: 1) Slide 2720 over and install a Valentine One on my Big Mak Shelf. 2) Install remote mute switch for V1. and 3) Install low-beam HID.

Some of the pics may come in handy for you.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top