BMW K1200, K1300, and K1600 Forum banner

TupperWare Removal

3K views 6 replies 5 participants last post by  dwm650 
#1 ·
I first did a search in advance mode, didn't find the answer.
1st time to remove Tupperware. What is the procedure ?
I don't mean to ask dumb questions, just acquired this 03 GT.

I have Clymers on order, but I like to do this today as I adding a Centech box for GPS, XM UniGo wire Harness.
Any guidance would be appreciated. :popcorn:
Dave
 
#2 ·
dwm650 said:
Any guidance would be appreciated. :popcorn:
Dave
- Here is an old thread > yours will be slightly different at the turn signals and you do not need to remove the belly pan.

http://www.k-bikes.com/forums/showthread.php?t=924&highlight=remove

- and a couple of more

http://www.k-bikes.com/forums/showthread.php?t=12717&highlight=remove

http://www.k-bikes.com/forums/showthread.php?t=12560&highlight=remove

- just grab your Torx and jump in. Be sure to note Razels comment in the first thread. Just because you havent had the tupperware off doesnt mean the last person that did put the screws back correctly.

- ebill
 
#3 ·
ebill said:
- Here is an old thread > yours will be slightly different at the turn signals and you do not need to remove the belly pan.

http://www.k-bikes.com/forums/showthread.php?t=924&highlight=remove

- and a couple of more

http://www.k-bikes.com/forums/showthread.php?t=12717&highlight=remove

http://www.k-bikes.com/forums/showthread.php?t=12560&highlight=remove

- just grab your Torx and jump in. Be sure to note Razels comment in the first thread. Just because you havent had the tupperware off doesnt mean the last person that did put the screws back correctly.

- ebill


Or all of them :D
 
#5 ·
:clap: You guys are great!
Thanks Fast response :thumb:
This is a great board, like sporttouring.com were I use to send a lot of time when I had my RT.
 
#7 ·
Zweirad, Thanks looked at your album. I too bought a Loom & Centech 1 from Eastern Beaver (no more 2's as there to hard to get).
All my assy. will be switched anyways.
But you gave me some Ideas from looking at your install.
I was wondering about Under seat clearance, It looks tight.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top