BMW K1200, K1300, and K1600 Forum banner

k13gt fuel Neck

2K views 5 replies 5 participants last post by  Meese 
#1 ·
Hi all-

Yup, I'm curious if I should drill the K13gt fuel filler neck like I did on the k12?

Why not an instant yes? Well the neck is different. The 13 had an orange plastic neck that looks a bit different. The 12's was metal.

Thanks in advance,

WL
 
#4 ·
GillyWI said:
Drill the filler neck?
Yes, sorry, thought it was common practice. Most of the new BMWs intensionally have a significant gap of air in the top of the tank. A totally filled tank can overflow a little, filling the charcoal canister, as the fuel changes from below ground temp (<50) to small vessel in the sun temp (80++). BUT its a bunch of additional gas. So if you don't fill to the brim then leave the bike (if you fill then ride) you'll be fine.

On most BMWs you can fill them pretty high if you wait, add, wait, add, wait, add. But if you put a hole or two in the filler neck towards the top, the fuel can more easily displace the air.

Additional info:
Here
Other Home

WL
 
#6 ·
I drilled mine when I first got the bike. I can squeeze in just barely under 7 gallons now. Like WL said, don't top off and let the bike sit, but for filling and getting right back on the road it works great.

If you're really worried you can also remove the charcoal canister, but most folks don't bother with that.

It's pretty easy to pull the filler neck out, but the fuel gauge strip stays attached so it's a bit fiddly. Just make sure to keep the holes below the top sealing surface.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top