BMW K1200, K1300, and K1600 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hi all, I just picked up a 2008 K1200s on the cheap and the BRAKE FAILURE light and the red triangle lights were on.. assuming it was the ABS module, I pulled it and sent it out to Module Master.. about $310 later, I have the my pump back with new brushes and a clean bill of health. My question is how do I bleed this thing once its all hooked back up?
Also, is there a working link with a service manual for download? I cant seem to find one anywhere.:grin

Thanks!!
 

·
Registered
Joined
·
7 Posts
Discussion Starter #2
Never mind...I got it going.. didnt know the GS911 turns on the ABS pump to bleed the air out after a conventional bleed.:grin
 
1 - 4 of 4 Posts
Top