BMW K1200, K1300, and K1600 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
my abs 1 - goes thru self test -most times will test ok & shut off .
but if temps are above 85 ish - next time i restart & self test runs again. it will tri[ to slow lt / rt flash)
gs 911 says piston failure. so i reset - and all is well till ??? . some times it just works & times it will trip.
is there any way to run ( jump wires) at pump to run it some - to get any air out or just run the thing to loosen it up ?
it has a good pedal & hand pressure feel - IE no air - pads good rotors good. brakes work fine / normal.
id think if i could cycle the pump some - it might help
i can start & run ( cycle abs) 10 times & all is ok - then it will just trip.
gs911 reset - then work & then trip.
any one know any tricks ?
 
1 - 1 of 1 Posts
Top