BMW K1200, K1300, and K1600 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
I just purchased a new full face helmet with clip release instead of D rings. I am presently locking it with a cable through the rear rack on my GT. Is there a neater way to secure a helmet without D rings?
 

·
Registered
Joined
·
14 Posts
I just installed the BMW lock from Pirates Lair and use a short cable with loops on each end through the chin bar. I had the lock set with my ignition key so one key fits all. Out of the way, easy to use and install.
 

·
Registered
Joined
·
57 Posts
I had the same problem with a Schuberth helmet with the buckle. I used a small soldering iron and burned a hole in the nylon strap. The hole doesn't fray and I just put the pin or loop from the helmet lock through the strap and latch. It's as secure and quick as putting it through a D ring.
 
1 - 3 of 3 Posts
Top