BMW K1200, K1300, and K1600 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
497 Posts
Discussion Starter #1
For those of you waiting, the beta release for WebUpdater and POI Loader for the Mac are available. I'm am beginning to run them with my NavIII and have not encountered any problems yet.

Brian
 

·
Registered
Joined
·
25 Posts
What does webupdater do? Update firmware or map software?
 

·
Registered
Joined
·
497 Posts
Discussion Starter #4
Tonopah said:
What does webupdater do? Update firmware or map software?
It pulls firmware updates from the web and loads them onto your Garmin GPS.

Brian
 

·
Registered
Joined
·
25 Posts
Thanks. I may try it on my Map60CS. Think I'll leave the Nav III the way it is for now as it is brand new.
 

·
Registered
Joined
·
25 Posts
Seemed to work fine on my Map60CS. I had never updated it before and there were sure a lot of updates that webupdater found to load.
My Mac is a G4 Powerbook. On an intel mac, can you install Windows (Bootcamp) and then install Garmin sofware on the Windows side and use it okay? My Nav III came pre-loaded but I do have the software disk too (mapsource plus City Navigator or whatever the Nav III uses, I guess). If I had an intel mac, I am wondering if I could install the Nav III software on the Windows side okay and use it from there.
 
1 - 7 of 7 Posts
Top