BMW K1200, K1300, and K1600 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Does anyone know if JB weld will hold a heat shield mounting bracket to my K100RT muffler? Their website says max temp of 500ºF, though they recommend for engine blocks/cylinders, etc. It's just a raised little square steel bracket on edge, to hold a capture nut for the tiny 6mm heat shield bolt. I guess i have nothing to lose, because if it breaks/cracks, i won't lose the expensive bracket/nut as it is bolted to the shield, and i could get it welded at a machine shop that does stainless. Thanks
 

·
Addict
Joined
·
3,750 Posts
I noticed a similar thing with mine and a crack in the shield. I discovered this can happen when working in the tight space to tighten up the bolts. If you aren't careful, the bolt head twists the moulding in the last couple of thread turns.

I also realised mine on the K12 wasn't metal but some sort of plastic I think. It also 'rings' and may be responsible for resonance noise. I've seen muffler covers in ABS, so I guess if it has enough air round it, it must be ok. I think I'm resigned to replacing mine, making sure there's a plain washer under the bolt head and being more careful in future.



Never pay again for live sex! | Hot girls doing naughty stuff for free! | Chat for free!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top