BMW K1200, K1300, and K1600 Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I was serving my brakes on my K1200s and change out all the fluid in the abs pressure modulator. All went well until i went to tighten the vent caps for the front and rear circuits. One of the caps snapped off as i was tightening it. I really didnt apply too much pressure either. Crap plastic!

In any case, Its either macgyer something together or order a new vent line from germany at a cost of $100can ( plus shipping I would imagine)

Does anyone have ideas on how to proceed. I dont think there is any pressure behind the cap, i believe its just an overflow for the circuit.
 
1 - 1 of 1 Posts
Top