BMW K1200, K1300, and K1600 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi,
I have to replace the clutch slave cylinder on a K1200S, problem is the only one available in my area is the one from K1300S.
Parts catalog just says "D=34mm" on the K1300S one (21 52 7 719 262) and "D=32mm" on the K1200S one (32 72 7 695 220). I think it's referring to the diameter of a piston inside, but I'm not sure of the external dimension and travel / engagement point.
Will it fit?
 

·
Registered
Joined
·
24 Posts
I don’t have an answer for you but I upgraded, with a Oberon, my heavy pull to me clutch slave cylinder. the original that I have is in good condition just sitting in a box. 2005 K1200s 24k miles when replaced.
if you pay for shipping you can have it gratis I see them on eBay etc. for $50-$60 used
 

·
Registered
Joined
·
5 Posts
I installed the k1300s slave on my k12 with no issues. Make sure the flat part is facing the clutch basket when you install it. Bleeding the cylinder is a bit of a pain, but is doable. Slightly less pull pressure, but requires a longer travel. John Sykes aka 4hundred4 once told me to avoid the Oberon since the part that contacts the clutch is round with no flat point so it can cause an indentation on the thrust adapter over time. Haven’t tried that one though.
 
1 - 3 of 3 Posts
Top