BMW K1200, K1300, and K1600 Forum banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
Long story short my ECU has been out for a remap - bike will push start but no button start. This issue occurred as soon as ecu came out- nothing to do with remap. Starter button seems to work tested back at ecu loom and worked perfectly before ecu was taken out. Battery voltage 13v at rest

Can anyone please give em advice on how to test the starter post ecu. I.e. is there and actual relay that can be tested or replaced, can starter be tested/engaged with a bypass. Wiring diagram would be great if anyone has one - apparently rarer than unicorns ?

I'm not after comments on ecu being damaged etc- that may be the case, I'm trying to diagnose everything else first as the bike runs perfectly and now beautifully since the remap has been done- needs to be pushed started though....

Regards from Australia :)
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.