BMW K1200, K1300, and K1600 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
2nd ride of the season and my cruise control does not work. It worked on my first ride which was yesterday. Any ideas. 06 gt 3500 miles.
 

·
Registered
Joined
·
275 Posts
Make sure your brakes are not on. Out of adjustment, enough to trigger the switch. That happened to me a few years back. My brake light was staying on.
 

·
Registered
Joined
·
100 Posts
Does the check run on startup?

Hi,
Normally when starting the GT you should see the "SET" in yellow characters on your dash.
If not I would guess that the controller is not functioning.
Just my 2 meager cents
André
 

·
Strafist
Joined
·
2,544 Posts
This is a diagnostic procedure we used on the LT. I don't know if it'll work on the GT as my bike is 30 miles away. But, have at it and let us know.

This procedure must be done exactly as follows while you monitor the "SET" light on the instrument cluster:

1) With the ignition switch OFF, switch on the cruise control. Press and hold the cruise control switch to the SET position and switch on the ignition switch (LIGHT).

2) Release the SET button (LIGHT GOES OFF), move the switch to the RESET position (LIGHT).

3) Release the button (LIGHT OFF), switch OFF the cruise control switch (LIGHT).

4) Switch the cruise control switch back on (LIGHT OFF).

5) Rotate the throttle against the throttle stop (LIGHT), release the throttle (LIGHT OFF).

6) Pull the clutch lever (LIGHT), release the clutch lever (LIGHT OFF).

7) Pull the front brake lever (LIGHT), release the lever (LIGHT OFF).

8) Push the foot brake pedal (LIGHT ON), hold for 5 seconds (LIGHT OFF), release foot brake pedal (LIGHT ON).

9) Rotate the rear wheel (LIGHT SHOULD GO OFF/ON).

10) Switch off the ignition.
 
1 - 5 of 5 Posts
Top