Same here...k1200sforme said:Some time ago there was a thread that told how to remove these brackets which I can't seem to locate, anybody?
Thanks Ken....evoluzione said:there are several ways to remove the passenger pegs but the easiest is to undo the three bolts, remove the oil tank support (it just pulls out of the tank) and then remove the lower subframe bolt. now you can just pull outward on the lower subframe arm (~1") and slide the passenger peg support out. remember to reinstall the oil tank support and bolt and lower subframe bolt. repeat on the other side.
hope this helps.
the oil tank support is just held in with a rubber grommet - try spraying a little wd-40 on it and it should slide right out. once that is done, the subframe will move (i've done at least 2 dozen bikes so far).
and here are two shots of our latest design that removes the entire assembly: