BMW K1200, K1300, and K1600 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
623 Posts
Discussion Starter #1
It's part #33117722890

Its a ring seal that goes on the driveshaft side of the axle. You know that ring area that's around the hole on the rear shaft.
BMW direction has you drilling a hole in it and pulling it out somehow with what seems like a slide dent puller.

Thanks for any help
Mike
 

Attachments

·
Registered
Joined
·
99 Posts
I haven’t done it myself but watched it done using two self tapping screws into the seal. Be careful not to screw them in too far and damage the seating surface. Quite an easy job. I haven’t done mine yet after 110k km.
 

·
Registered
2009 K1300S, 2017 S1000R
Joined
·
477 Posts
Start at 2 minutes and go to 4 minutes, the part you need to see.
 
  • Like
Reactions: heefner
1 - 5 of 5 Posts
Top