Throttlemeister Install

4971 Views 6 Replies 5 Participants Last post by BillyOmaha, Aug 1, 2006

DallasKRSRider

Discussion Starter · Oct 23, 2005 (Edited)

I bought Throttlemeister bar ends for my 02 KRS, used, and they arrived with no instructions or spacers. I have heated grips and have no idea what is inside the grip once I cut out the end. I was told these bar ends came off of an RS with heated grips, but who knows, and I don't know if I have the right internal connectors. I could really use a set of instructions or a step by step procedure before I go and F*&K up my heated grips.

These are the parts I received, look at the screw heads.

Ken Bowen
Dallas, TX

See less See more

Save

1 - 1 of 7 Posts

BillyOmaha

· #7 · Aug 1, 2006

Just a suggestion, turn on the heated grips to high temp and wait about 10 minutes. If the spacers are not adequate, then the throttle will bind even with the ThrottleMeister at the full open position.

If it does bind, add some spacers.

.