BMW K1200, K1300, and K1600 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
A month ago, after disconnecting the battery, my 05 K1200S started running like shit. Wouldn't hold idle, start without throttle, like it is running way rich.

Bike had been running perfectly. I do have (and have had) a Power Commander 5 on it, it's been on for about 9 months.

With the Power Commander completely removed, I get 0 readings from the TPS. Voltage is at 4.72v on center pin, one of the outside pins has 4.91v with key on engine off.

With the Power Commander installed, I get 19.2%-100% throttle, but can't get below 19.2% throttle.

I've replaced the TPS with a second hand one, but have the exact same problem.

Any ideas?
 

·
Registered
Joined
·
651 Posts
After reconnecting the battery, did you do the twist-throttle-from-idle-to-full-three-times-in-succession-with-ignition-on-but-engine-off procedure?
 
1 - 3 of 3 Posts
Top